OFERTA
Obuwie standardowe dla dzieci
Obuwie ortopedyczne
Obuwie medyczne
Obuwie dla dorosłych
Wkładki
Tailor-made footwear is always made on the basis of individual foot parameters. Therefore, in addition to specifying the corrections to be applied to the footwear, the order should contain the following data:
Standing on a sheet of paper, outline the contour of the circumference of the foot. To draw the foot correctly, you need to hold the pencil at a right angle to the foot.
Measure in cm the distance between the farthest points in the figure (a and b)
In AurelKaorto® brand footwear, the abbreviation can be made in the sole or in the insole (inside the shoe).
The method of performing the correction is conditioned by the height of the shortcut.
Possible variants of execution of modifications:
The abbreviation inside should not exceed 1 cm in the hindfoot and 0.5 cm in the forefoot. The outer part of the shortcut can have a different height depending on the individual needs of the customer.
The abbreviation is always performed with a chamfer starting at the height of the fifth head of the metatarsal bone (2/3 of the length of the subsole).
It is also possible to carve in the heel part, which makes it easier to roll the foot at higher abutments.
At the request of the customer, the shortcut can be made without reaming, and with the same height for the rear foot as in the forefoot.
The table contains the minimum measurements of the orthosis and is only used to assess whether the orthosis will fit into the shoe. The measurement of the width of the heel and forefoot is final. The adjustment margin is only present in the measurement of circuits. Thanks to the adjustment of the laces and the softness of the skin, the circumference of the orthosis can be slightly larger than the stated minimum.
Serial shoes may not be perfectly matched to the orthosis. The straps in the shoes must be adjusted and shortened by yourself. Any unusual orthoses require individual implementation.
So that the shoes are not too tight, you need to add about 1 cm to the measurements of the length of the insole.
%20copy.jpg)
.webp)
%20copy.webp)
